-The kind of this clamping shaft coupling is sensitive and in any case need to use the right method and the right tools. In the process of storage, transportation and installation, the parts of bearings should not be damaged. Some bearings require greater pressure, so special tools are needed. Be sure to refer to the car manufacturing instructions. When installing bearings, they should be installed in a clean and tidy environment. Small particles entering bearings will also shorten the service life of bearings. It is very important to keep a clean environment when replacing bearings. It is not allowed to knock the bearing with a hammer, and pay attention to the bearing not falling to the ground (or similar improper handling). Before installation, the condition of the shaft and bearing seat should also be checked. Even tiny wear will lead to poor fit, resulting in early failure of the bearing.
-Centres the shaft to the hub
-High transmissible torques
-Short axial width
-For shaft diameters between 20 mm and 200 mm
